All telecom fundamentals on SIP protocol, VOIP, RTP, RTCP knowledge, Technical Youtube Videos, Linux material, Android, SSCA certification information,the sip school videos.

Friday, 28 September 2012

IPSI firmware upgrade through CLI

Below is the procedure to upgrade the IPSI firmware through command line.
To upgrade ipsi firmware, run the below commands. Firmware file should be in /var/home/ftp/pub directory.
1) Upload the firmware file on IPSI board.
Syntax : loadipsi -c “IPSILOCATION” -f /var/home/ftp/pub/filename
Server1> loadipsi -c 1a -f /var/home/ftp/pub/TN2312BP-f39-sig.bin
Generating public/private dsa key pair.
Your identification has been saved in /tmp/authkey20999.
Your public key has been saved in /tmp/authkey20999.pub.
The key fingerprint is:
5d:96:4b:2f:3e:66:e0:ea:33:49:a9:9e:8d:06:80:e7 server1
Failed to add the host to the list of known hosts (/var/home/defty/.ssh/known_hosts).
sftp> put /var/home/ftp/pub/TN2312BP-f39-sig.bin i220024.f47
Uploading /var/home/ftp/pub/TN2312BP-f39-sig.bin to /i220024.f47
Connection to closed by remote host.
Burning flash may take several minutes......done
IPSI Firmware Download: All done: SUCCESS.
2) Once you have uploaded the file on IPSI, reset the IPSI board.
Syntax : resetipsi -c IPSILOC
server1> resetipsi -c 1a
IPSI reset: IPSI: ipsi-A01a, IP: Successfully reset .
Note :If you have duplicated IPSI's, and when you are upgrading firmware on active IPSI, interchange the IPSI on SAT terminal through "set ipserver-interface board location of new active IPSI".



Post a Comment

Note: only a member of this blog may post a comment.

Page Navigation Widget